4
Operation of your milk frother
I. Frothing and heating
1. Place the appliance on a
fl
at surface.
2. Select frothing paddle, then open the lid and insert the frothing paddle onto the shaft on
the bottom of jar.
3. Fill the jar with the desired amount of milk, and replace the lid, observing
fi
ll lines
Note
:
the max milk quantity permitted to add is 100ml, to avoid milk over
fl
owing after
frothing.
4. Place the jar on the power base and connect the plug into a power outlet, the indicator
light will turn red.
5. Press the power button once, the indicator light will turn blue. Then the appliance will
start to work. Once the temperature of milk has achieved approximately 68 Degrees, the
heating element will stop heating and the frothing paddle will stop rotating automatically;
the indicator will illuminate red again until unplugging the power outlet.
Note
:
During operation, you can stop operating by pressing the power button once.
6. When the appliance has stopped operating, pour out the warmed and frothed milk to
enjoy it.
Caution
: A minimum of 3 minutes rest time must be maintained between cycles. Otherwise
after 5 continuos cycles continuously the appliance will enter self protection mode. When
this occurs, the indicator light will illuminate and
fl
ash blue. In addition the power button will
not be activated.
After Approximately 5 minutes the appliance will enter standby mode and the machine is
then ready for use.
7. Always turn off the milk frother and disconnect the power supply when not use
II. Only frothing separately, without heating.
1. Following steps 1-4 in the section of “Frothing and heating”.
2. Press the power button three times continuously within 2 seconds, the indicator light will
illuminate blue and
fl
ash, the frothing paddle will then rotate for frothing milk separately,
but the heating element will not heat. The appliance will automatically stop rotating after
operating. The indicator light will illuminate red again until unplugging the power outlet.
Note
:
During operation, you can stop frother by pressing the power button once.
3. When the appliance has stopped operating, pour out the frothed milk and enjoy it.
Caution
: A minimum of 3 minutes rest time must be maintained between cycles. Otherwise
after 5 continuos cycles continuously the appliance will enter self protection mode. When
this occurs, the indicator light will illuminate and
fl
ash blue. In addition the power button will
not be activated.
After Approximately 5 minutes the appliance will enter standby mode and the machine is
then ready for use.
4. Always turn off the milk frother and disconnect the power supply when not use.
English
Summary of Contents for F02MK
Page 7: ...7 English...