CT-BOX User’s Manual
17
1.5
Start-Up Configuration
The CT-BOX unit can be configured to start-up (after a power cycle) with two
different configurations:
-
Saved
configuration;
-
Desktop
configuration.
Please note that these two alternate configurations are only valid for start-up and
they do not affect the other functionalities of the unit in any manner. These start-up
modes can be set by a DIP switch placed on the rear side of the CT-BOX enclosure.
1.5.1
Saved Configuration
The CT-BOX starts with the last saved configuration that was configured to the
device. The position of the DIP switch #4 of the rear panel needs to be set as shown
hereafter (HIGH position):
Figure 10
:
Saved
Configuration at start-up
The device will be configured directly at start-up with the last configuration – e.g.
Data-logger or Oscilloscope mode, all other parameters. This allows to starting up the
device with the last configuration that was set by the user.
1.5.2
Desktop Configuration
The CT-BOX starts with a standard configuration if the position of the DIP switch
#4 of the rear panel is set as shown hereafter (LOW position):