Document type:
Title:
Revision date:
Revision:
User's Manual (MUT)
A3000NF 3Phase Notch Filter for A3486
18/06/2008
4
NPO:
Filename:
Number of pages:
Page:
00120/04:3000N.MUTx/04 A3000NF_REV4.DOC
13
9
2. Safety information and installation requirements
2.1 Injury
Precautions
Review the following precautions to avoid injury and prevent damage to this product or
any products connected to it. To avoid potential hazards, use the product only as
specified. Only qualified personnel should perform service procedures.
2.1.1 General
Recommendations
The A3000NF is provided with front panel fixing holes for 19" rack-mounting and will
occupy 3U of rack space. Rear support should be provided when fitted in a 19" rack.
The A3000NF is a heavy unit (32kg) and should be regarded as a two-man lift. Take
suitable precautions when lifting.
When rack-mounting the unit needs natural convection of air over the case and an
unrestricted air flow through the unit. The A3000NF will operate as a free-standing unit
without requiring any special cooling arrangement, but should not be allowed to be
accidentally or deliberately covered over in any way. Do not operate the unit with the top
cover removed as this exposes hazardous voltages.
WARNING: THE A3000NF ACTUALLY OBSTRUCTS THE VERTICAL AIR
FLOW THROUGH THE RACK!
2.1.2 Caution
The following safety precaution must be observed during all phases of operation, service
and repair of this equipment. Failure to comply with the safety precautions or warnings in
this document violates safety standards of design, manufacture and intended use of this
equipment and may impair the built-in protections within.
CAEN shall not be liable for user’s failure to comply with these requirements.
To avoid electric shock or fire hazard, do not apply a voltage to a load that is outside the
range specified for that load.
To avoid electric shock or fire hazard, do not operate this product with covers or panels
removed.
Do Not Operate Without Covers.
To avoid electric shock or fire hazard, do not operate this product with covers or panels
removed.
Do Not Operate in Wet/Damp Conditions.
To avoid electric shock, do not operate this product in wet or damp conditions.
Do Not Operate in an Explosive Atmosphere.
To avoid injury or fire hazard, do not operate this product in an explosive atmosphere.
Do Not Operate With Suspected Failures.
If you suspect there is damage to this product, have it inspected by qualified service
personnel.
WARNING: ALL ENCLOSED ELECTRICAL/ELECTRONIC EQUIPMENT
SHALL BE PROVIDED WITH A MEANS FOR DISCONNECTING IT FROM EACH
