- Lepton
7
- Technical Information Manual
21
5
REGULATORY COMPLIANCE
RoHS EU Directive
The Lepton
7
R7100C RFID Reader is compliant with the EU Directive 2015/863/EU on the Restriction of the
Use of certain Hazardous Substances in Electrical and Electronic Equipment (RoHS3).
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
a.
Reorient or relocate the receiving antenna.
b.
Increase the separation between the equipment and receiver.
c.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
d.
Consult the dealer or an experienced radio/TV technician for help.
This transmitter module has been tested and found to comply with Part 15 of the FCC Rules.
NOTE:
a.
Any changes or modifications not approved by CAEN RFID could void the user’s authority to operate the
equipment.
b.
Lepton
7
R7100C module is approved for operation with the following antenna:
CAEN RFID antenna Mod. WANTENNAX020 Circular polarized antenna FCC with 5.5dBi gain
In order to operate the Lepton
7
R7100C under FCC ID: UVECAENRFID034, the OEM must strictly follow these
antenna guidelines:
• The OEM may operate only with the following antenna or antennas of the same type with maximum gain as
shown:
CAEN RFID antenna Mod. WANTENNAX020 Circular polarized antenna FCC with 5.5dBi gain
• RF I/O interface to the antenna connector on the PCB shall be accomplished via a microstrip or stripline
transmission line with characteristic impedance of 50 ohms +/- 10%. A custom coaxial pigtail may also be
utilized to connect to the antenna in lieu of a connector.
• The connector on the OEM’s PCB which interfaces to the antenna must be of a unique type to disable
connection to a non-permissible antenna in compliance with FCC section 15.203.
• The OEM must professionally install the Lepton
7
R7100C into its final environment to ensure that the
conditions are met.
c.
The device shall be used such that a minimum separation distance of 20cm is maintained between each antenna
and user's/nearby people's body.
