CADnetwork RenderCube XL, Manual

Page: 21 / 49

Re RenderCube XL
1-21
1.1.9 Internal connectors
1. Intel ® Serial ATA 6 Gb/s connectors (7-pin SATA6G_12, SATA 6G_34, SATA
6G_56/SATAEXPRESS_1, SATA6G_78, SATA6G_910)
These connectors connect to Serial ATA 6 Gb/s hard disk drives via Serial ATA 6 Gb/s
signal cables.
If you installed Serial ATA hard disk drives, you can create a RAID 0, 1, 5, and 10
configuration with the Intel
®
Rapid Storage Technology through the onboard Intel
®
X99
chipset.
• These connectors are set to [AHCI Mode] by default. If you intend to create a Serial
ATA RAID set using these connectors, set the SATA Mode item in the BIOS to [RAID
Mode]
. Refer to section
3.6.3 PCH Storage Configuration
for details.
• Before creating a RAID set, refer to the manual bundled in the motherboard support
DVD.
• The SATAEXPRESS_1 connector can support one SATA Express device or two
SATA devices.
• Due to chipset behavior, the SATA6G_78 and SATA6G_910 ports do not support
Intel
®
Rapid Storage Technology and RAID configuration.