TR-MAN-1500
Operator's Manual - Mini-Travellers
Page 31 of 83
Cadman Power Equipment ▪ BOX 100, Courtland, Ontario, Canada N0J-1E0 ▪ Phone: 519-688-2222 ▪ Fax: 519-688-2100 ▪ www.cadmanpower.com
Step 2
Once you have fastened the booster pump to the traveller review page 68 the
Booster Pump Harness section to wire the Booster Pump Harness to the E-stop and
Shut-off switch of the traveller. Before wiring make sure the battery is disconnected
from the unit.
Make sure to disconnect the battery plug from the equipment. Failure to
disconnect the battery from the equipment before hooking up the wiring
harness could result in equipment damage and may result in serious injury
to you and/or spectators.
Step 3
Connect your water supply to the booster pump suction. Then connect the booster
pumps discharge to the inlet feeder pipe of the traveller.
Figure 36
– Booster Pump Discharge/ Supply Lines
img-00720
Step 4
Prime the pump by filling the casing and supply line with water.
WARNING: DO NOT run the pump before priming it, the seal and impeller
could become permanently damaged.
Step 5
Check the Fuel level and Oil level before starting the engine. Once you confirmed the
fluid levels, turn the engine
ON
by pulling the pull cord on the side of the Honda engine.