Cadillac 2006 DTS, Owner'S Manual

Page: 162 / 448

Driving with Intellibeam™
Intellibeam™ will only activate your high-beams when
driving over 20 mph (32 km/h).
The high-beam headlamps will remain on, under the
automatic control of Intellibeam™, until any of the
following situations occur:
•
The system detects an approaching vehicle’s
headlamps.
•
The system detects a preceding vehicle’s taillamps.
•
The outside light is bright enough that high-beam
headlamps are not required.
•
The vehicle’s speed drops below 15 mph (24 km/h).
•
The headlamp stalk is moved forward to the
high-beam position or the flash-to-pass feature is
used. See Headlamp High/Low-Beam Changer
on page 3-9 and Flash-to-Pass on page 3-13.
When either of these conditions occur, the
Intellibeam™ feature will be disabled and the
Intellibeam™ light in the mirror will turn off until the
high-beam stalk is returned to the neutral position.
•
If Intellibeam™ was using low-beams prior to this
action, the Intellibeam™ feature will be temporarily
disabled until the stalk is returned to the neutral
position.
•
The exterior lamp control is turned to any setting
except AUTO.
When this occurs, Intellibeam™ will be disabled
until the control is turned back to the AUTO position.
•
The Intellibeam™ system is turned off at the inside
rearview mirror.
Intellibeam™ may not turn off the high-beams if the
system cannot detect other vehicle’s lamps because of
any of the following:
•
The others vehicle’s lamp(s) are missing, damaged,
obstructed from view or otherwise undetected.
•
The other vehicle’s lamp(s) are covered with dirt,
snow and/or road spray.
•
The other vehicle’s lamp(s) cannot be detected due
to dense exhaust, smoke, fog, snow, road spray,
mist or other airborne obstructions.
•
Your vehicle’s windshield is dirty, cracked or
obstructed by something that blocks the view of the
Intellibeam light sensor.
•
Your vehicle’s windshield is covered with ice, dirt,
haze or other obstructions.
3-32