2-38
Turn and Lane Change Signals
To signal a turn, move the turn signal/multifunction
lever all the way up or down. The lever returns
automatically when the turn is complete.
This arrow on the
instrument panel cluster
will flash in the direction of
the turn or lane change.
Raise or lower the lever until the arrow starts to flash to
signal a lane change. Hold it there until the lane change
is complete. The lever returns when it is released.
Arrows that flash rapidly when signaling for a turn or
lane change may be caused by a burned
-
out front signal
bulb. (This does not occur with a burned
-
out rear bulb).
Other drivers won’t see the turn signal. Replace
burned
-
out bulbs to help avoid possible accidents.
Check the fuse (see “Fuses and Circuit Breakers” in the
Index) and for burned
-
out bulbs if the arrow fails to
work when signaling a turn.
Headlamp High/Low Beam
With the Twilight Sentinel
R
on or with the lamp
control dial turned to the headlamp position, push the
turn signal/multifunction lever on the driver’s side of
the steering wheel away from you to turn on the
high
-
beam headlamps.
This light on the instrument
panel cluster will be on,
indicating high
-
beam usage.
Pull the lever back to the original position to return to
low
-
beam headlamps. For more information, see
“Headlamps” in the Index.
Flash-To-Pass
This feature uses the high
-
beam headlamps to signal the
driver in front of you that you want to pass. This feature
will work with either the headlamps on or off.
To use, pull the turn signal lever toward you and release.
