Cadet NLW202T Owner'S Manual Download Page 4

INSTALLATION INSTRUCTIONS 

(continued)

Supply 

Ground 

Wire

__________________________

     

 

Part Two

      

__________________________

               

Install Heater Assembly

STEP 1

Place heater assembly inside wall can and secure 

with two screws (provided).

               

Install Grill

STEP 3

Secure grill with the screws provided. Slide thermo-

stat knob onto shaft. Turn power on at the electrical 

panel board.   
Important:  Before turning on power, be sure the 

thermostat knob is turned counter clockwise to the 

lowest setting, and the switch is in the “FAN” or 

“AUTO” position.

After you have followed all instructions in PART ONE, for either new construction or an existing wall,  you are 

ready to install the heater assembly.

How do I insert the heater assembly into the wall can?

STEP 2

 

Route Supply Wires

Route supply wire from circuit breaker to top of wall can. Remove 

knockout and attach the supply wire with a strain relief connector, 

leaving 6 inches of wire lead for later use. Connect supply ground 

wire to grounding screw in wall can (See Figure 3).  
Proceed to PART TWO.

STEP 3

 

Mount Wall Can

Insert wall can into opening. Keeping front of wall can flush with 

wall, secure to wall stud with screws through the four larger (3/16 

inch) holes. Connect supply ground wire to grounding screw in 

wall can (See Figure 3).   
Proceed to PART TWO.

__________________________

     

 

Part One

 

     

__________________________

How do I install for new construction?

How do I install in an existing wall?

Figure 5

              

Wire Connections

STEP 2

Connect the 2 heater wires to the 2 supply wires us-

ing electrical insulated wire connectors (see Figure 

5). Push wires into wiring junction box.

Page 4

Reviews: