•
The Hot One may sit on a floor surface or
be mounted to the wall, or on the ceiling,
using the universal stand provided.
• If mounted on the wall, maintain 6 inch
minimum clearance from the top of the unit
to the ceiling (See Figure 2).
• Recommended for elevations under 7500
feet.
STEP 1
Heater Inspection
STEP 2
Mounting
1. Remove stand from heater by loosening knobs on each side.
2. Place stand in desired position on wall (See Figure 3). Note: A 240 volt receptacle must be within
six feet of the heater.
3. Using a level across the top of the stand, mark the three keyhole locations indicated (See Figure
4). IMPORTANT: the top, center keyhole must be screwed into a wall stud.
4. Insert one of the 2 inch screws provided into the top, center keyhole position, leaving enough of the
screw sticking out to attach the stand later.
5.
Using a ⅜ inch drill bit, drill holes through the drywall in each of the two bottom keyhole positions.
Insert drywall anchors (provided) in each hole.
6. Insert the drywall anchor screws until completely screwed in. Then back each anchor screw out
about ½ inch. Place the stand on the three exposed screws and tighten all three screws.
7. Place heater on stand and tighten knobs.
8. Proceed to OPERATING INSTRUCTIONS.
WALL MOUNT
INSTALLATION INSTRUCTIONS
4
Figure 2
Thoroughly inspect your heater for any
shipping or handling damage and remove any
paper or packaging material around the heater.
TIPS BEFORE YOU BEGIN
3' (92 cm) min. clearance
from front of heater
12" (30.5) min. clearance
from sides of heater
6" (16 cm) min.
clearance from
back and
top of heater
Distancia mínima
de 3 pies (92 cm) delante
del calentador
Distancia mínima
de 12" (30.5 cm) desde los
costados del calentador
6" (16 cm) desde
la parte posterior
y superior
del calentador
Figure 3
Figure 4
Wall Mount
screw
drywall
anchor
drywall
anchor
