SAVE THESE INSTRUCTIONS
IMPORTANT INSTRUCTIONS
1. Read all instructions before install-
ing or using this heater.
2. This heater is hot when in use. To
avoid burns, do not let bare skin
touch hot surfaces. Keep combus-
tible materials, such as furniture,
pillows, bedding, papers, clothes,
etc. and curtains at least 3 feet (0.9
meters) from the front of the heater
and keep them away from the sides.
3. Extreme caution is necessary
when any heater is used by or near
children or invalids and whenever
the heater is left operating and
unattended.
4. Do not operate any heater after it
malfunctions. Disconnect power
at service panel and have heater
inspected by a reputable electrician
before reusing.
5. Do not use outdoors.
6. To disconnect heater, turn control(s)
to off, and turn off power to heater
circuit at main disconnect panel.
7. Do not insert or allow foreign
objects to enter any ventilation or
exhaust opening as this may cause
an electric shock or fire, or damage
the heater.
8. To prevent a possible fire, do not
block air intakes or exhaust in any
manner.
9. A heater has hot and arcing or
sparking parts inside. Do not use
it in areas where gasoline, paint,
or flammable vapors or liquids are
used or stored.
10. Use this heater only as described
in this manual. Any other use not
recommended by the manufacturer
may cause fire, electric shock, or
injury to persons.
11. This heater must be installed in a
fixed, permanent location.
When using electrical appliances, basic precautions should always be followed
to reduce the risk of fire, electric shock, and injury to persons, including the
following:
KNOW YOUR VOLTAGE!
120 volt
single-pole breaker
240 volt
double-pole breaker
• The multi-volt CE163T and CE083T Energy Plus heaters are equipped with a smart
sensor that will auto adjust to your voltage supply.
The CE162T can only be connected to 240 volts, and the CE168T can only be
connected to 208 volts.
If you are uncomfortable working with electricity, running electrical supply wire or
installing a circuit breaker, please consult a licensed electrician. Make sure power to
the heater is turned off at the main disconnect panel whenever doing any work on a
heater. Serious injury or electrocution can result from electric shock.
• CHECK YOUR BREAKER! If you’re replacing an existing heater, check the labels of
the old heater and use the same voltage.
Unanswered questions? Call our technical support team in Vancouver, Washington
toll free at
855.223.3887
or outside the USA
360.693.2505
2
WARNING: Connecting a heater to a voltage higher than what’s listed on its rating
label will destroy the heater and could start a fire. A heater will not heat properly
when connected to a voltage lower than what’s listed on its rating label.