26
Figure 29
IMPORTANT:
The fins on the cooling fan are only
slightly flexible. Be careful not to damage the fan when
removing the drive belt from around the transmission
pulley.
•
Reroute the new belt around the pulleys and belt
keepers, if present, EXACTLY as the old one was
routed. Refer to Figure 29.
HYDROSTATIC TRANSMISSION
The hydrostatic transmission is sealed at the factory and
is maintenance free. The fluid level cannot be checked
nor can the oil be changed. Always keep the area
around the transmission cooling fan free of grass and
debris at all times.
SECTION 11: OFF-SEASON STORAGE
If the machine is to be inoperative for a period longer
than 30 days, prepare for storage as follows.
WARNING:
Never store the machine or fuel
container indoors where there is an open
flame, spark or pilot light such as on water
heater, furnace, clothes dryer or other gas
appliance.
WARNING:
Use a fuel stabilizer additive or
drain the fuel into an approved container
outdoors, away from an open flame. Allow
engine to cool. Extinguish cigarettes, cigars,
pipes and other sources of ignition prior to
draining fuel.
•
Clean the engine and the entire unit thoroughly.
•
Lubricate all lubrication points. Wipe the entire
machine with an oiled rag to protect the painted
metal surfaces.
•
Refer to the engine manual for correct engine
storage instructions. The engine must be completely
drained of fuel to prevent gum deposits from forming
on essential carburetor parts, fuel lines and fuel
tanks.
•
It is not necessary to remove the battery from the
tractor for storage. However, clean the top of the
battery and make sure it has full charge. Disconnect
the negative terminal of the battery before storing
the tractor.
•
Store unit in a clean, dry area.
NOTE:
When storing any type of power equipment in
an unventilated or metal storage shed, care should be
taken to rustproof the equipment. Using a light oil or
silicone, coat the equipment, especially any chains,
springs, bearings and cables.
FRONT OF TRACTOR
Fixed V-idler Pulley
Transmission Pulley
Engine Pulley
Hydrostatic
Double-Idler Bracket
V-idler Pulley
NOTE:
View shown from above tractor.
Idler Extension Spring
Drive Belt
Left Frame Rail
Flat idler Pulley
(Beneath Cooling Fan)
Transmission
Summary of Contents for CLT-180
Page 29: ...NOTES 29...
Page 30: ...NOTES 30...
