Cadel Alessia, Installation, Use And Maintenance Handbook

Page: 78 / 96

Pag. 78
MARTINA-SOLARIS-ALESSIA-VANESSA
5.14. PROGR.SETT (weekly setting)
Ignition and turning off the stove can be programmed day by day for seven days with 2 daily stages
(PROGRAM 1 and PROGRAM 2). Remember that button P4 can be used to quit programming at any
time. The parameters for the chronothermostat are as follows:
UT01 Sets current day and mode.
UT02 Sets current hours.
UT03 Sets minutes.
UT04 Sets technical parameters (reserved)
UT05 Sets ignition time PROGRAM 1
UT06 Sets turning off time PROGRAM 1
UT07 Selects the days of the week with stove ignition in the morning.
UT08 Sets ignition time PROGRAM 2.
UT09 Sets turning off time PROGRAM 2.
UT010 Selects days with stove ignition in the afternoon.
To see if the chronothermostat is active, check the items “Day” (active) on UT1 and “OFF”(deactivated).
Below there are details of the meaning of some parameters.
UT01 : is used to enter the weekly program in “Day” or exclude it if in “Off”. Select the day of the week
from “Day1”, which corresponds to Monday, to “Day7”, which is Sunday. If the UT01 parameter is set with
current day (e.g. Day2, i.e. Tuesday) you can select the day of the week to associate ignition with
PROGRAM 1 and/or PROGRAM 2. Press buttons P1 and P2 to select the desired value.
UT05-UT06 : indicate the start and finish times to ignite the stove in PROGRAM 1. These settings are
active if the UT01 parameter is set on weekly mode.
UT07: this parameter is active when parameter UT01 is set on weekly mode. When PROGRAM 1 is active,
use the P1 button to select the day of the week and the P2 button to activate/deactivate stove ignition.
UT08-UT09: indicate the stove start and finish time in PROGRAM 2. The settings are active if the UT01
parameter is set on weekly mode.
UT010: this parameter is active when the UT01 parameter is set on weekly mode. When PROGRAM 2 is
active use the P1 button to select the day of the week and the P2 button to activate/deactivate stove
ignition.