Cadco BAKERLUX SHOP.Pro XAKHT-HCFS, Installation, Use And Maintenance Manual

Page: 26 / 40

A
PLUMBING
� CONNECTIONS
INCOMING WATER
The bottom of the appliance
contains two meters of pipe with
a tee for connecting to the oven
water supply (including mechanical
filter and fitting (3/ 4") with non­
return valve).
A shut-off valve should be positioned
between the water mains and the
appliance.
� Use thesetofnewconnections
'U'
supplied with the appliance
for the connection to the
water mains. Connections that
have already been used must not
be used again.
I &
WARNING!
The equipment
must be Installed with adequate
backflow protection to comply
with applicable federal, state and
local codes.
INLET WATER CHARACTERISTICS
� Any damage caused by using
'U'
water with parameters that do
not correspond to what is
specified in this section is not
covered by the warranty.
The water supply must:
- have a maximum temperature of
86 °F (30 °C);
- be drinkable;
- be pressured at between 22 and 87
psi (150-600 kPa).
26
� If water pressure at the inlet is
¥
less than the minimum
specified value (22 psi - 1.50
bar) a pump (minimum water flow
rate 1.32 gpm (300 1/h)) is required.
The ovens have a built-in pressure
reducer.
If water conductivity is greater than
150 µS/cm a water treatment for
steam production is required.
Damage caused by limescale
or other chemical agents is not
covered by the warranty