Cadco BAKERLUX SHOP.Pro XAKHT-HCFS, Installation, Use And Maintenance Manual

Page: 25 / 40

� Connections to the main power
W
and the electrical system must
comply with the regulations in
force in the country of installation of
the appliance; and all connections
must be performed by qualified
personnel authorised by Cadco.
Failure to comply with these
regulations may cause damage and
injuries, invalidates the warranty* and
relieves Cadco of all liabilities. Before
connecting the appliance to the
mains electricity, always compare the
power supply data with that of the
appliance specified on the rating
plate. The appliance is released from
the factory with power cable and plug
already connected to the terminal. Do
not make any other type of electrical
connection and no dimensional
modification of the cable other than
extensions, replacing it only with
one having specifications equal to
the original factory cable (type of
rummer, cross-section, etc.).
� The cable must be replaced by
� Cadco or by its
technical assistance service, and in all
cases by a person with similar
qualification in order to avoid possible
risks.
� The wiring diagrams, wire
¥
specifications and the technical
data are indicated on the
"Technical specifications" sheet
attached to the appliance.
For proper electrical connections, the
appliance must:
Be wired into an equipotential
system in accordance with current
regulations. This connection must
be performed between different
appliances with the terminal marked
with the equipotential symbol
if)
. The cable must have a maxim�
crnss-section of 10 mm2 (pursuant
standard CEI EN 60335-2-42:2003-
09) and be of yellow-green colour.
- Must be grounded • to the
earthing (green-yellow�re).
- Must be connected to a ther­
mal differential switch in compli­
ance with the regulations in force
(0.03A Type A).
- Must be connected to a omni po­
lar circuit breaker mechanism that
enables complete disconnection
in category Ill over voltage condi­
tions.
CHECKS
- The copper jumper in the termi­
nal board and the electrical cable
must be secured together under
the screw in its tightening direc­
tion; and the electrical connec­
tions must be securely tightened
before connecting the appliance
to the electricity mains.
- Check for any electrical disper­
sion between the phases and the
ground, and for electrical conti­
nuity between the external casing
and the main ground line.
- Check that the power supply volt­
age does not deviate from the
nominal voltage value specified
on the appliance rating plate when
the appliance is operating. If this
is not the case, wire the phases as
specified on the "technical specifi­
cations" sheet attached.
l it
WARNING!
Electrical Grounding Instructions: appliance is equipped with
a three-prong (grounding) plug for your protection against shock hazard and
should be plugged directly into a properly grounded three-prong receptacle.
Do not cut or remove the grounding prong from this plug.
25