INSTALLATION AND OPERATION
NOTE TO SYSTEM INSTALLER
System installer must adhere to Article 820-40 of the NEC that
provides guidelines for proper grounding and specifies that the
cable ground shall be connected to
the grounding system of the
building
, as close to the point of cable entry as practical.
1. UNPACKING and HANDLING
Each unit is shipped with all equipment assembled, and factory tested.
Ensure that all accessories are removed from the container before discarding packing material
2. MECHANICAL
INSPECTION
Inspect the front and rear of the equipment for shipping damage. Make sure the equipment is
clean, and no connectors are broken, damaged, or loose. If equipment appears to be damaged
or defective please contact us at 1-610-429-1511 for assistance.
3. PRODUCT
DIAGRAM
c
d
e
h
g
f
i
1
Power
“Power-On” indicator light
2
RF Gain
For RF gain adjustment
3
Tilt
For Slope adjustment over the entire bandwidth
4
In
Input RF signal from headend combiner is connected to this port
5
Out
Amplified RF signal is available to the main RF distribution network
from this port
6
Test Port
-30dB output test port for system monitoring
7
Power Cable
For connection to a 115 VAC, 60Hz outlet
3
