FRAME RELAY CONFIGURATION
WPIM-SY LOCAL MANAGEMENT GUIDE
2-13
The WAN configuration is complete. It takes up to 60 seconds for the
WAN Interface to come out of standby and for communications to begin.
2.5
FRAME RELAY CONFIGURATION
This section provides instructions for connecting the WPIM-SY to a DDS
(Digital Data System) circuit in a Frame Relay environment. This
example assumes the setup shown in Figure 2-4 using two MicroMMAC
hubs with WPIM-SY modules installed in each BRIM-W6.
Figure 2-4. WPIM-SY Interface Configuration for Frame Relay
The line configuration information shown in Table 2-1, “Telco
Configuration Information,” on page 8 must be supplied by the service
provider.
Table 2-3. Telco Configuration Information
Configuration Information
Required By User
Configuration Information
Supplied By Service Provider
Clock Source
Telco provided or no clock source
Circuit Speed
64K, V.35, RS-422, RS-232, etc.
Upon saving this screen, the interface just configured is
assigned to an application port (PT#) in the table on the right
hand side of the screen once the device starts communicating
with the service provider’s switch.
NOTE
Telco Cloud
CSU/
DSU
CSU/
DSU
MicroMMAC #2
with BRIM-W6
SITE #2
MicroMMAC #1
with BRIM-W6
SITE #1
1483_03
