4
Checking the Installation
The SmartStack Token Ring Switch performs a diagnostic
self-test during the power on cycle. From a management
console, check that the switch lists the STS-LM port along
with the switch ports and that there are no error messages. The
STS-LM port will be listed as port 29.
If, after installation, there is poor system performance or the
STS-LM module does not work at all, remove the module and
check for any damaged or bent connector pins. You may need
a bright light to see inside the stacker slot to check for bent
pins. Also, verify that the module is set firmly in place.
❏
Getting in Touch With Technical Support
For additional support related to this device or document,
contact Cabletron Systems using one of the following
methods
:
Menu
Parameter
IP Configuration
IP Address, IP Gateway, IP Subnet, IP
State
Spanning Tree
STP Enabling/Disabling, STP Switch
Priority, STP Maximum Aging, STP
Hello Time, STP Forward Delay
Virtual LAN
Name
Configuration
Changing VLAN names
Password
System password
Console
Configuration
Console Time-out
Telnet
Configuration
Number of Allowed Telnet Sessions,
Disallow New Telnet Sessions
TFTP Download
TFTP Server Address, Download
Domain, Download Filename
Switch/Stack
Information
Stack Timeout, System Name, System
Contact, System Location
SNMP
Configuration
Send Authentication Traps, changing
the Trap table in any way, changing the
Community Name table in any way
Table 3. Inter-box Parameters
World Wide Web
http://www.cabletron.com/
Phone
(603) 332-9400
Internet mail
FTP
ftp://ftp.cabletron.com/
Login
anonymous
Password
your email address
To send comments or suggestions concerning this
document, contact the Cabletron Systems Technical
Writing Department via the following email
address: [email protected]
Make sure to include the document Part Number in the
email message.
STS-LM Stacker Link Module
for
SmartStack Token Ring Switch
Installation Guide
Trademarks
SmartStack is a trademark of Cabletron Systems, Inc. All other brands or product names are trademarks
or registered trademarks of their respective holders.
Copyrights
Cabletron reserves the right to modify the information given in this publication without prior notice. The
warranty terms and conditions applicable for your purchase of this equipment are given at the time of
purchase. Please consult them for details.
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or
transmitted, in any form or by any means, electronic, mechanical, photocopying, recording or otherwise,
without the prior written permission of the publisher.
Publication: OC-7057 v. 1.0, 710001713
Part Number: 9032991
© February 1999 by Cabletron Systems, Inc.
FCC Compliance
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be
required to correct the interference at his own expense.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
CLASS 1 LASER PRODUCT
* 710001713*
