Cabletron Systems MMAC-M3FNB, Overview And Setup Manual

Page: 27 / 28

MMAC-M3FNB SETUP
Page 3-7
b. With the LEDs at the top of the M3PSM and the handle to the
right, align the M3PSM with the slotted paths on the top and
bottom of the opening.
c. Ensuring that the power supply is inserted into the slotted
paths, carefully slide the module forward until it is connected
to the backplane and its front panel is flush with the front of
the MMAC-M3FNB. Do not force the module into place. If you
encounter significant resistance before the front panel is flush
with the MMAC-M3FNB, remove and reinsert it.
Figure 3-4. Installing the Power Supply Module
4. Tighten the knurled knobs to secure the M3PSM to the
MMAC-M3FNB.
After you have finished installing the power supply module, the
MMAC-M3FNB is ready to be powered up; however, we recommend
that you first install the repeater/management module and the MIM
M3FM
M3 FAN
MODULE
M3PSM
POWER
~LINE: 50/60 Hz
100-125VAC 4A
200-250VAC 2A
FAN STATUS
SN
The Complete Networking Solution™
The Complete Networking Solution™
The Complete Networking Solution™
SN
MMAC-M3FNB
MULTI-MEDIA ACCESS CENTER
The handles provided on the fan tray and power supply
are for installation only; they are not designed to
support the full weight of the chassis, and should not
be used as carrying handles.