Chapter 2: Controls and Indicators
Page 2-4
MicroMMAC Installation Guide
2.3.2 Saved Alarm Messages
Saved Alarm messages describe events that occur within the
MicroMMAC or on the network. Table 2-2 shows each Saved Alarm
message. To view Saved Alarm messages, perform the following steps:
1. Press the Display button for five seconds and then release to view the
first Saved Alarm message in the message queue.
2. Press and immediately release the Display button to scroll through
each subsequent message.
If the Display button is not pressed again for 10 seconds, the LCD
defaults to the product name.
Table 2-2
Saved Alarm Messages
Displayed Messages
Comments
No Messages in Queue
No Alarm messages in queue. This is the
default setting.
Port xxxxxx
Segmented
Displays segmentation status of network ports
1–24, EPIM-1 or EPIM-2.
Port xxxxxx
UnSegmented
Displays segmentation status of network ports
1–24, EPIM-1, or EPIM-2.
Port xxxxxx
Link Established
Displays link status of network ports 1–24,
EPIM-1, EPIM-2, or BRIM-1.
Port xxxxxx
Not Linked
Displays link status of network ports 1–24,
EPIM-1, EPIM-2, or BRIM-1.
EPIM-x
Inserted
Displays installation status of EPIM-1 or
EPIM-2.
EPIM-x
Removed
Displays installation status of EPIM-1 or
EPIM-2.
EPIM-x
Security Violation
Indicates unauthorized access attempt at
EPIM-1 or EPIM-2.
CableRedun Fail
Port EPIM-x
Indicates failure of redundant link at EPIM-1 or
EPIM-2.
CableRedun Enable
Indicates redundant link enabled.
Port EPIM-x
EPIM-1 or EPIM-2.
Port xxxxxx
Disabled
Indicates network ports 1–24, EPIM-1, or
EPIM-2 disabled.