Using the LCD and LCD DISPLAY Button
MicroMMAC Installation Guide
Page 2-3
2.3.1 Static System Messages
Static System messages provide MicroMMAC configuration information.
Table 2-1 lists each message. To view Static System messages, perform
the following steps:
1. Press and immediately release the Display button to view the first
Static System Message in the queue.
2. Press and release the Display button to display each subsequent
message.
If the Display button is not pressed again for ten seconds, the LCD
defaults to the product name.
Table 2-1
Static System Messages
Displayed Messages
Comments
IP Address
xxx.xxx.xxx.xxx
Displays the MicroMMAC’s IP address. The IP
address can be changed through Local
Management.
MAC Address
00001dxxxxxx
Displays the MicroMMAC’s MAC address (this
address is also called the physical address).
RAM Image
Rev. xx.xx.xx
Displays the revision number of the image
currently executing in FLASH.
Boot PROM
Rev. xx.xx.xx
Displays the revision number of the internal
Boot PROM.
Flash Programmed
xx Times
Displays the number of times FLASH has been
programmed.
COM 1 Port
Baud Rate xxxxx
Displays the Baud Rate for the COM 1 port. The
default setting is AUTO because the
MicroMMAC uses Auto-Baud detection.
COM 1 Port
Function xxxxx
Displays the current function of the COM 1 Port
(N/A, UPS, LM).
COM 2 Port Baud Rate
xxxxx
Displays the baud rate for the COM 2 port. The
default setting is AUTO because the
MicroMMAC uses Auto-Baud detection.
COM 2 Port
Function xxxxxx
Displays the current function of the COM 2 Port
(N/A, UPS, LM).
