Chapter 4: Management
4-14
HSIM-W87 User’s Guide
4.3
SAMPLE IMUX CONFIGURATION
The following is a sample of a common configuration.
To perform an IMUX configuration for the setup shown in
Figure B-1
, in
Appendix B
, follow these steps:
1.
To add channels to an IMUX group:
Enter: imux 1 -ac 1 29
(this adds interface 29 to the group id 1 in the imux id 1)
To display the setup so far:
Enter: imux 1
Figure 4-3
shows the imux setup for group id 1 so far:
Figure 4-3
Adding Channels to an IMUX Group
imuxsetup1
-> imux 1 -ac 1 29
# Inverse Multiplexer channel with ifIndex 29 added to group 1
-> imux 1
#
# WAN Inverse Multiplexer 1 Status: Disabled
#
# Inverse WAN Available Xmit Byte Inverse
# Multiplexer Group Physical BW Count Multiplexer Channel
# ID Admin Status Number (bits/sec) (bytes) ID IfIndex Status
#-------------------------------------------------------------------------------------------------------------
# 1 Disabled 22 1536000 0 1 29 INACTIVE
#
#
# Number of WAN Inverse Multiplexer Groups currently programmed : 1
#
# Number of WAN Inverse Multiplexer Channels currently programmed : 1
