Cabletron Systems CSX100 series, User Manual, Page: 120 / 153

ISDN Router 106
•
Re-enter the correct password and hit enter. Remember that the
password is case-sensitive. Check that you are entering
admin in
lowercase and that the Caps key is not active.
•
If you have forgotten the password, you must reset the login password.
Refer to the appendix A,
Changing Configuration Switches, and perform
the following procedure:
1 . Move switches 5 and 6 down.
2. Type
login newpasswd
. Password checking is overridden.
3. Move switches 5 and 6 up .
4. Complete any configuration update that caused the prompt for login.
5. Change your login password to a new password.
6. Store the configuration and reboot the router.
Note: If you have not reset switches 5 and 6 up and have rebooted, you will
place the router in maintenance mode. Set switches 5 and 6 up and turn the
power off and then on.
Problems accessing the remote network
•
Start the Port Monitor and check the status of the ISDN B-channels
which should be in “Standby” mode.
•
Check that the ISDN line SPIDs and DNs (if required) are valid, the
telephone switch settings are correct and the line can be activated.
•
Verify that the ISDN phone numbers are correct for the remote router.
•
If you are not using the supplied ISDN cable, check that the cables are
pinned correctly.
•
Verify that PAP/CHAP passwords are correct. Ensure that the remote
router operates at the same minimum level of security that you have set
in the target router.
If Bridging
•
Check that the Bridging Default Destination has been set.
•
Check that bridging to/from the remote router is set on.
•
Be sure to reboot if you have made any bridging destination or
control changes.