Remote Annex Quick Start for Windows
3
❑
The
na
and Quick2Config Annex software can be loaded on
Windows NT Workstations (3.51 or 4.0) and on Windows 95
platforms.
❑
Quick2Config Annex can be installed on Windows for
Workgroups 3.11 and Windows 3.1 systems.
To install Quick2Config Annex on a Windows platform:
1
Put the CD-ROM into the Windows NT server’s CD drive.
2
Use the File Manager to select the CD-ROM disk.
3
Double-click on the setup.exe file.
4
Follow the dialog box instructions to select Install Software and
then Quick2Config Annex.
5
When prompted for an installation directory, accept the default
directory for each software module.
Refer to
Installing Remote Annex Network Software for Windows
for
information about installing the
na
and Quick2Config Annex software on
Windows platforms.
If you are installing Quick2Config on a Windows 3.1 or
Windows for Workgroups 3.11 platform, you may be
required to install additional software that is provided on
the CD-ROM. See
Installing Remote Annex Network Software
for Windows
for details.
Hardware Setup
To set up the Remote Annex hardware:
1
Connect the power and connect the Remote Annex to the
network. If you are setting up a Remote Annex 6300, connect
CSU (DTE) to the Remote Annex and connect CSU (Net) to the
PRI Line.
2
Connect the console cable and terminal.
The Remote Annex 4000, 6100, and 6300 have a dedicated
console port.
Summary of Contents for CSMIM-T1
Page 1: ...Title Page CSMIM MICRO CS QUICK START FOR WINDOWS NT...
Page 2: ......
