16
One of the key features to the CabKing-6V3 is the single pass, contamination-free water system.
The water system will remain trouble-free as long as you use a fresh, clean supply of water. Do
this by using a separate intake water bucket from the drainage bucket. A fresh supply of water
will protect you from cross-contamination of grit which can occur in re-circulating systems that
use a bubbler or geyser. With fresh water, the pump and intake tubes will stay clean and
unobstructed so there will be enough water pressure. The water pump is rated at 30watts,
605GPH, 8.2ftHmax. We recommend using a minimum 5 gallon bucket for both the water pump
and drainage. You will typically go through an average of 1-2 gallons of water per hour, with the
water control knobs on a light to medium drip. Monitor the water level in the bucket to make
sure the water pump is always submerged in water.
THE WATER PUMP SHOULD NOT BE RUN
DRY. UNPLUG WATER PUMP FROM POWER SOURCE WHEN NOT IN USE.
By design, all water system parts can be easily disassembled by pulling off or unscrewing and
cleaned with soapy water. For routine maintenance, keep the nozzles, y-split and tubing clean
with a small wire brush or the included pipe cleaner.
DO NOT SET-UP THE WATER SYSTEM AS A RE-CIRCULATING SYSTEM. THIS WILL VOID YOUR
WARRANTY.
This means putting the drip pan tubes into the same bucket of water as your water
pump. Doing so will void your warranty and you also risk cross-contamination of grit, which
may result in scratches on your stone. The grit will eventually build up in the water control
valves, nozzles and tubing which will restrict water flow and potentially clog the water system
parts.
Underneath each hood are three y-splits with two nozzles in each, three needle valves and clear
tubing that connects to each needle valve. The clear tubing measures 1/4
″
outer diameter X
1/8
″
inner diameter. See image below to identify parts.
CABKING WATER SYSTEM PARTS
NOZZLE
CLEAR TUBING
NEEDLE VALVE
Y-SPLIT
