2
Till Roll Installation
1. With the terminal facing up, gently pull upwards on the lever located in the middle of the
printer door.
2. Discard any packing material from the paper roll.
3. Fit the roll as shown in the diagrams above. If installed incorrectly the terminal will
produce blank receipts.
4. Gently pull between 5-10 cm of paper until it shows from the top of the terminal.
5. Close the printer door until a ‘Click’ is heard.
6. Tear off the excess paper.
Charging the Terminal
1. Inset the power supply plug directly into the side of the terminal.
2. Charging of the battery will take between 2 and 4 hours.
The battery level is indicated on the top right of the terminal screen. (if required, you can
charge the battery by using the in-car charger provided.)
Turning the Terminal ON/OFF
1. To turn ‘ON’ the terminal hold down the power button (located on the top right of the key
pad)
2. The terminal will show Initialization please wait, followed by connecting please wait or
press ‘x’ to configure. Do not do anything at this point and allow your terminal to find and
connect to available networks in your area.
3. To turn ‘OFF’ the terminal hold down the power button (located on the top right of the key
pad)
The terminal will turn ‘OFF’ after a period of inactivity to conserve battery power. This is
normal and can be turned back ‘ON’ by following step 1 above.