OUTDOOR MOUNT
-
When used horizontally outside or in humid environment, be
assured that the loudspeaker is positioned as shown on page
3
with the Cabasse logo on the right hand side.
Optimal positioning for a 2.0 or stereo system
If «d» is the distance between the two speakers, this distance
must be higher than 5 ft (1.5 m) and the two speakers must
be at equal distance from the listening area which forms with
them an equilateral triangle.
The drivers must be directed towards the listening area.
The speakers should be located so that their diffusion fol-
lows the longest dimension of the room.
Generally speaking it is better to avoid putting the speakers
in the corners of a room as this amplifies the low frequencies
and tends to enhance the room resonances.
Placing the speakers in niches is not recommended. Unless
designed for this application, bookshelf placement will alter
the frequency response of the speaker, especially in the low
frequencies. If a bookshelf location cannot be avoid, the
speaker should be set up to minimize various resonance, and
the visible part of the grille must be outside the niche.
WEEE MARK
Disposal of Wastes of Electrical & Electronic
Equipment (Applicable in the European Union)
This symbol on the product, consisting of the
crossed-out wheeled bin, indicates that this
product shall not be treated as household
waste. Instead it shall be handed over to the
applicable collection point for the disposal
of electrical and electronic equipment at the end of life. By
ensuring this product is disposed of correctly, you will help
prevent potential negative consequences for the environment
and human health, which could otherwise be caused by inap-
propriate waste handling of this product. The recycling of
materials will help to preserve natural resources. For more
detailed information about recycling of this product, please
contact your local city office, your household waste disposal
service or the shop where you purchased the product.
UNPACKING
1
After opening the top carton flaps, fold the carton flaps right
back, remove the cardboard sheet, the bag of accessories
and the foam halfshells protecting the speakers and the front
grille. Then pull out the grill and the speaker. We suggest you
to retain the packing for future use.
WALL MOUNT WITH THE STANDARD
YOKE BRACKET
1) Prepare all the necessary parts and tools : the yoke bracket,
and the screws, plugs and drilling equipment suitable for the
type of wall and a spirit level.
2) Position the bracket on the wall at the chosen spot, check
the up and down orientation, check it is with the spirit level
aligned and drill 2 holes through the bracket holes. Insert the
plugs in the wall.
3) Place the damping stickers on the back of the bracket and
mount the bracket with right screws.
4) Fit the loudspeaker into the arms of the bracket, gently
hand tighten both knobs.
5) Connect the loudspeaker cable to the terminals. Ensure
that polarities are correct (see ¶ Phase).
6) Swivel the loudspeaker to the right angle and tight both
nobs.
WALL MOUNT WITH THE OPTIONAL
BALL BRACKET
1) Prepare all the necessary parts and tools: the ball bracket
and screws, plugs and drilling equipment suitable for the type
of wall and a spirit level.
2) Mount the bracket part with two holes on the back of the
loudspeaker, place the other part of the bracket on the wall
and use it as a drilling template, control the alignment and
drill the holes through the bracket. Place the inserts in the
holes.
3) Assemble both bracket parts, swivel the loudspeaker in the
right direction and tighten the bolt.
4) Connect the loudspeaker cable to the terminals. Ensure
that polarities are correct (see ¶ Phase).
ZEF 13
These speakers are very heavy, so 2 persons minimum are
required to unpack and re-pack them.
ATTENTION :
Direct long exposure to sunshine or bad
weather can affect the look of you loudspeakers. We recom-
mend the mounting under a canopy for fair weather periods
followed by removal and storage in winter.
Be assured that the wall can handle the weight of the louds-
peaker and that the selected plugs do suit with the wall cha-
racteristics.
CAB Notice ZEF 13.indd 9
06/04/12 10:31