27
8.4
Cut-out Mark Dimensions
Labels with cut-out marks
Endless material with cut-out marks
Feed direction
for marginal cut-out marks
minimum liner thickness 0,06 mm
Figure 26
Cut-out mark dimensions
Dim.
Designation
Dim. in mm
A
Label distance
> 2
N
Width of cut-out mark
> 5
P
Height of cut-out mark
2 - 10
X
Distance mark - middle of paper track
for gap sensor recognition
for reflective sensor recognition
-10 or 0
-56 up to +10
Y1
Y2
Sensor recognized virtual label front edge
with reflective sensor recognition
1)
with gap sensor recognition
Front edge cut-out
Rear edge cut-out
Z1
Z2
Distance recognized front edge - actual label front edge
with reflective sensor recognition
with gap sensor recognition using transparent labels
Adjust software settings
P up to A
0 up to A-P
1)
Backside of the material must be sufficiently reflective.
Table 11
Cut-out mark dimensions
Marginal cut-out
Long hole cut-out
Rectangular cut-out
Circular cut-out
Not recommended !
Cut-out
between the labels
Not recommended !
Figure 27
Samples for cut-out marks
8 Media
