3
1 - Supply roll hanger
2 - Label adjust guide
3 - Knurl screw
4 - Axle
5 - Rollers
6 - Axle
7 - Dispense plate
8 - Display with RESET button
9 - Dispensed label
10 - Microfeeler
11 - Power switch
12 - Knurl screw
13 - Axle
14 - Sensor block
15 - Rewinder clasp
16 - Rewinder hub
17 - Power cord connector
18 - Media roll
4. Operation
• Verify that the voltage setting shown on the
power cord connector (17) corresponds to the
input supply voltage, and if necessary reset
as follows: Open the flap on the module and
remove the voltage selector. Exchange the fuse
(use 250 mA for 250 V and 500 mA for 115 V),
and replace the voltage selector so that when
the module flap is closed, the relevant voltage
setting is visible through the cut-out in the flap.
• Using the mains cable supplied, connect the
HS 150 to the mains supply, ensuring that an
earthed socket is used.
• Loosen the knurled screw (3) and swing the
guide (2) upwards. Mount the label-stock roll
(18) onto the main axle (1), so that the labels to
be dispensed are visible from above.
• Slide the roll of label stock up to the side panel
of the HS 150.
• Feed the label strip as shown in the accom-
panying diagram. This diagram relates to
externally wound label stock.
• Affix the end of the label strip to the rewinder
axle(16) by using the clamp provided (15),
which locates into the two longitudinal slots in
the axle.
• Note that the axle rewinds in a clockwise
direction!
• Swing the guide (2) downwards and slide it
sideways along the axle (4) until it rests against
the label roll in such a manner that when the
dispenser is in operation, the roll is lightly
retarded.
• Tighten the knurled screw (3).
• Adjust the position of the sensor block (14)
in relation to the size of labels to be dispensed
(see part 5).
• Position the rollers (5) mounted on the axle (6)
so that they press down onto the label strip.
When so positioned, the rollers improve the
donor mode when particularly irregular label-
stock is being used, and thereby improve the
positioning of each peeled-off label in order to
operate the micro-switch
• Switch the machine ON (using ON/OFF switch
(11). The label feed will start immediately and
the first label will be peeled from the backing-
strip by the peel off plate (7). This label causes
the micro-switch (10) to operate and the feed is
stopped. When the label is removed, the next
label is fed into position and the feed is again
stopped.
• The total number of labels dispensed is shown
in the LED display (8). To reset the counter to
"0" press the reset button.
18
2
4
10
11 12 13 14 15 16
17
1
6
8
5
3
7
9
