CAB EOS4, Configuration Manual

Page: 12 / 48

12 12
4 Configuration
4.1.2 Machine Parameters

Start Offline menu.

Select
Setup > Machine param.
.
Parameter Meaning Default
Printhead pos. X
Shifting of the entire print image perpendicular to the direction of
paper flow.
The absolute shifting is limited by the margins of the print zone.
Those are determined by the width of the printing line on the
printhead. The
Printhead pos. X
can also be set via software.
The offset values from the Machine param. menu and the
software are added together.
0,0 mm
Printhead pos. Y
Shifting of the entire print image in the direction of paper flow. With
positive values, printing begins later in the direction of paper flow.
Shifting of the print image in the direction of paper flow also influ-
ences the cut position.

Correct the
Cut position
parameters by the same value in the
opposite direction.
The Printhead pos. Y can also be set via software. The offset
values from the
Machine param.
menu and the software are
added together.
0,0 mm
Tear-off pos.
Shifting of the tear-off position in the direction of paper flow. With
positive values, the label strip is transported farther out of the printer.
0,0 mm
Demand sensor
Configuration of the peel-off parameters for devices with dispenser module.
If dispenser module is not installed, access only with service key
inserted
> Peel position
Offset of the peel position relative to the rear label edge.
The
Peel position can also be set via software. The offset values
from the Machine param. menu and the software are added
together.
0,0 mm
> Backfeed delay
Delay time between removing the label from the peel position and
the backfeed of the label.
250 ms
> Liner tension
Setting of the peel-off tension
Access only with service key inserted
0%
Cutter
Configuration of the cut parameters for devices with cutter.
If cutter is not installed, access only with service key inserted
> Cut position
Offset of the cut position relative to the rear label edge.
The
Cut position can also be set via software. The offset values
from the Machine param. menu and the software are added
together.
0,0 mm
> Cutting depth
with perforation cutter only
Setting of the perforation depth.
The
Cutting depth can also be set via software. The offset values
from the Machine param. menu and the software are added
together.
0
Backfeed
position
Offset of the backfeed movement
1,0 mm
Brightn. LCD
Brightness of the LCD display from 1 to 8.
8
Contrast LCD
Contrast of the LCD display from 0 to 15.
6
Volume Speaker
Volume of the speaker : Mute, 1 or 2.
1
Time Powersave
Time between the last operation and activation of energy-saving
mode.
5 min