10
10
4
Operation
4.2 Operation in Peel-off Mode
1
3
4
1
2
4.2.1 Standard Operation
Under
Setup
->
Print param.
->
Print on demand
select the setting
Off
. (
Configuration manual).
Active the peel-off mode in the software. With direct programming it is
controlled with the "P command" (
Programming manual).
Send a print job.
The first label (3) will be printed, fed into the peel-off position and removed
from the liner (4) excepting the last ca 2 mm.
Remove the label. The removal will be registered by two see-through
sensors (1). If both sensors are free, the next label will be printed.
!
Attention!
When operating multi-lane media remove at last the labels which
are detected by the sensors (1).
4.2.1 Print on Demand
Under
Setup
->
Print param.
->
Print on demand
select the setting
On
. (
Configuration manual).
Active the peel-off mode in the software. With direct programming it is
controlled with the "P command" (
Programming manual).
Send a print job.
The first label (3) will be printed, fed into the peel-off position and removed
from the liner (4) excepting the last ca 2 mm.
Remove the label.
Select
to start the next label.
