CAB CABTHUMB.32, Manual

Page: 18 / 48

18 ENG
If the protective function “Block (
Bloc
)” is on, you must press
a sequence of buttons on the device (see figure to the side)
to access the channel or group mode. The device comes with
the “Block (
Bloc
)” mode disabled. To activate the function
use the menu (see SETUP). With the “Block (
Bloc
)” function
enabled, if you press any button on the remote control, on display appears the message (
Bloc on
).
The unlock function is used to avoid pressing keys accidentally or to prevent the device from being used by unauthorized persons.
The above combination is used both to lock and unlock the device.
SBLOCCO DISPOSITIVO
FUNZIONI STANDARD (UTENTE) :
MODALITÀ CANALE
MODALITÀ GRUPPO
ATTIVA CANALE/SU
ATTIVA CANALE/GIU
ATTIVA GRUPPO/SU
ATTIVA GRUPPO/GIU
1sec
1sec
1sec
1sec
ACCESS TO CHANNEL MODE ACCESS TO GROUP MODE
COMBINATION OF BLOCK/UNLOCK
SEND TRANSMITTER CODE/UP SEND TRANSMITTER CODE/DOWN
SBLOCCO DISPOSITIVO
FUNZIONI STANDARD (UTENTE) :
MODALITÀ CANALE
MODALITÀ GRUPPO
ATTIVA CANALE/SU
ATTIVA CANALE/GIU
ATTIVA GRUPPO/SU
ATTIVA GRUPPO/GIU
1sec
1sec
1sec
1sec
and buttons allow you to access the channel mode (transmission of a single code) and the group mode (transmission of
a code group). After selecting the desired mode, select the channel or group with the buttons or .
Press and hold for 1 sec the increase or decrease button to send the signal.
In channel mode (
Ch
) you can associate different functions to increase and decrease key for each of the 32 channels available.
In group mode (
Gr
), select the desired group (from
A
to
F
) using the keys or and type the send signal button. All channels
present in the selected group are transmitted.
4) USER GUIDE