38
38
1.3
7
6
6.1
15.1
15
Place the cylinder 'pliers' (6) with the tappet (6.1) on the
holder (1.3) of the base plate (1).
Insert the tappet (6.1) in the recesses (15.1) of the pliers
jaws (15).
Attach the compact cylinder (6) with the screws (7) on
the holder (1.3) of the base plate (1).
Fig. 42
Mount the 'pliers' cylinder
15
2.1
13
6.1
20 mm
Adjust pliers opening
Loosen nut (13).
Turn the cylinder piston (2.1) in the tappet (3) until the
pliers jaws (15) are 20 mm apart.
Measuring points, see picture
Tighten nut (13).
Insert the tubes into the connectors and throttle valves.
Mount and adjust sensors.
The following sensors must be set:
•
Sensors on cylinder 'flag'
„6.14.2 Set Cylinder 'flag' sensors“
•
Sensors on cylinder 'peel position'
„6.16 Set Cylinder (3.0) 'peel Position'“
•
Sensors on cylinder 'pliers'
„6.15.2 Set sensor on cylinder 'pliers'“
Fig. 43
Adjust pliers opening