C-Tech SYE-2000BS, Product Manual

Page: 7 / 11

- 5 -
Repeat the procedures 4.3.5 above.
⑦ . The test result will be printed automatically when a group of test specimens is completed. If
necessary, press “Print” key to print the test result when one or two piece of specimens of the
group is tested. Care must be taken that if the code “7” or “ 8” is input, only the six pieces of the
specimens are tested completely can the test result be printed out.
⑧ . The number will be added automatically when a group of specimens is tested completely. Repeat
the procedures 4.3.5 for the next test if the same kind of specimen will be test. Press “Reset”
key and repeat the procedures from 4.3.1 to input the new code if the different specimen will be
tested.
V. Data Searching
① . Press “Func” key until the indicating lamp “Information” flashed and press “Enter” key.
② . “P0000” and “S---2” will be displayed on the windows.
③ . Input the 4-digit and the code, and press “Enter” key for searching
④ . “E-01” will be displayed if the data can’t be traced. 4-digit will be displayed on the Force Value
window and the force value will be displayed on the Loading Rate window if the data is traced.
⑤ . Press “Print” key to print the traced test result if necessary.
VI. Verification and Calibration
The testing machine must be verified every year by the authorized department. The pressure
controller must be verified and calibrated by the qualified persons, otherwise the data will be in
disorder or lost.
Verification
Verify the controller with a third-grade proving ring after the machine is turned on for about 3 minutes.
Generally, 5 set loads (10%, 20%, 40%, 60% and 100%) of the full range will be verified.
① . Place the proving ring on the testing machine and apply the load to the rated value for three
Gear switch