User Manual: Interactive Digital Signage
SW601990 Rev H, Page 13 of 36
Chapter 5: Operation
Power
To turn the touchmonitor on or off, press the touchmonitor power button once. If a computer
module is installed, then the computer module will also turn on with the monitor.
To abruptly power off the computer module and touchmonitor, press and hold the touchmonitor
power button until the computer shuts off.
To gracefully shut down the computer module, follow the computer modules operating systems
normal power off procedure.
A Power Status LED is provided on the OSD Remote that functions according to the following
table:
Touchmonitor/Computer Module status
LED status
OFF OFF
SLEEP BLINKING
ON ON
The system consumes low power when in SLEEP and OFF modes. For detailed power
consumption specifications, refer to technical specifications available on the Elo website
www.elotouch.com.
Touching the screen will bring the system out of MONITOR SLEEP mode.
If long periods of disuse are planned, unplug the AC power cable to save power.
The maximum voltage, frequency and current for the touchmonitor are provided in the power
ratings table below:
Operating Voltage
Range
Operating Frequency
Range
Operating Current
Range
ET32/4201L
100 - 240Vac
50/60 Hz
3.6 – 1.5 A
ET5501L
100 - 240Vac
50/60 Hz
5 – 2.1 A
ET7001L
100 - 240Vac
50/60 Hz
5 – 2.1 A
