25
WIRING
Step 6:
Connect the TIP (negative) terminal of the DC adapter jack to the
eyelet on the PCB labeled “-“. Connect the SLEEVE of the DC adapter jack
to the eyelet on the PCB labeled “+” farthest to the right. The BATTERY
lug is not connected.
Also connect the enclosed audio jacks and the switching jack to the PCB.
The SLEEVE connection on the enclosed jacks will go into the ground
spots, and the TIP connection will connect to the ‘in’ and ‘out’ eyelets.
The SLEEVE connection of the switching jack will go to the GROUND
eyelet, the RING connection of the switching jack will go to the +V eyelet,
the right TIP connection of the switching jack will go into the C.V. eyelet,
and the left TIP connection will go into the P eyelet. All of this is shown
below.
Summary of Contents for Phase Royal
Page 8: ...8 Step 2 Add the header sockets...
Page 18: ...18 At this point your build will look like this Front...
Page 19: ...19 Back...
Page 28: ...28...
