BYOC Parametric EQ, Instructions Manual

Page: 13 / 27

Step 6: Add wires to the IN, OUT, RING, and two Ground eyelets. Start by cutting four
2.5 pieces of wire and one 1.5 piece of wire. Strip 1/4 off each end and tin the ends.
Tinning means to apply some solder to the stripped ends of the wires. This keeps the
strands from fraying and primes the wire for soldering. Solder a 2.5 piece of wire to each
of the IN, OUT, and Ground eyelets on the PCB. Solder the 1.5 piece of wire to the
RING eyelet on the PCB. Load the wires in from the top and solder on the bottom of the
PCB.