BYOC Li'l Analog Chorus Kit, Building Instructions, Page: 22 / 26

Step 4: Solder ONLY 1 of the footswitch lugs .
Your PCB should be recessed inside the enclosure about 1cm. It should be
level.
Some of your components may be sticking up out of the enclosure just a bit,
particularly the film capacitors. This is to be expected. This is OK. The lid
has a deep recess.
If you need to adjust the position of the PCB so that it fits correctly, reheat
the single solder joint you just made on the footswitch. Adjust the position
of the PCB while the keeping the solder joint hot. Remove the heat and hold
the PCB in position while allowing the solder joint to cool completely.
Now solder the rest of the footswitch lugs.
Step 5: Once you have your PCB positioned and soldered, guide the LED
into its enclosure hole using the leads that are sticking up through the PCB.
Once the LED is in position, solder and trim the excess leads.
Operating Overview