BYOC Large Beaver Triangle, Instructions Manual

Page: 15 / 23

Step 3: Hold the PCB in one hand so that the component side of the PCB is
in the palm of your hand and the bottom side with the pots and LED are
facing up. Now use your other hand to guide the predrilled enclosure onto
the PCB assembly so that the pots and LED all go into their respective holes.
Once the PCB assembly is in place, secure it by screwing on the washers and
nuts for the pots. Only tighten them with your fingers.
You do not want
them very tight yet. Make sure you’ve removed the nuts and washers from
the pots and that you’ve also snapped the tabs off the pots as well before
installing.
Step 4: Turn the entire pedal over so that the component side of the PCB is
facing up. Lift the PCB up off the pots about 2mm just to make sure that the
back of the PCB does not short out against the pots. Make sure the PCB is
level and symmetrically seated inside the enclosure.
Step 5: Solder the pots and LED. You will solder these parts on the
component side of the PCB. After you have soldered them in place, be sure
to tighten up their nuts. Be careful not to burn any of the components on the
PCB. If you do, it won’t harm anything, but it will look ugly.