21
FOOT SWITCH SOLDER LUG DESIGNATIONS
Step 2:
Begin wiring the foot switch. Orient the footswitch so that the flat sides of the
solder lugs are like the diagram above.
NOTE:
There are no actual number markings on the footswitch. There are two correct
ways you can orient the footswitch. They are both 180 degrees of each other. Either way
is fine. It does not matter as long as the flat sides of the solder lugs are running
horizontal, not vertical.
Step 2a:
Make a jumper between lugs 3 & 6 from clippings from the resistors. Simply
use your needle nose pliers to make a U shape & insert into lugs 3 & 6, then solder.
Summary of Contents for Gray 1976
