secure. If your transistors come out easily, then you have not installed them correctly and
you will likely not get a good connection, and this will likely lead to a poor sounding
pedal.
Once you have installed your transistors, adjust the bias trimpot to taste. You can use
your ear for this. There is no correct bias voltage. Install the base of the enclosure with
the 4 screws that came with your kit. Add the rubber bumper feet...unless you're a velcro
person. Add the 2 knobs. Be sure not to tighten the set screw inside the knobs too tight
or you may strip them. If you've got any problems that you can't figure out yourself, visit
board.buildyourownclone.com
for technical support. Please read the trouble shooting
guide first.
