Finishing Touches
Install the chips. NOTE: The PT2399 chip will likely have a “dot” on one end that is not
a marker that should be used for orienting the chip. Refer to the u-shaped notch when
orienting the chip. The DIP8 dual op amp may have a u-shaped notch, a dot in one
corner, or both for orienting. If the chip has both, always refer to the u-shaped notch
first.
Install the base of the enclosure with the 4 screws that came with your kit. Add the
rubber bumper feet...unless you're a velcro person. Add the 2 knobs. Be sure not to
tighten the set screw inside the knobs too tight or you may strip them. If you've got any
problems that you can't figure out yourself, visit board.buildyourownclone.com for
technical support. Please read the trouble shooting guide first.