·
Cut 3 x 2 pieces of wire. Strip 1/4 off each end. These will be used to connect the
tip and sleeve of the IN jack and the tip of the OUT jack to the PCB.
·
Cut 1 x 1.5 peice of wire. Strip 1/4 off each end. This will be used to connect the
ring of the IN jack to the ring eyelet on the PCB.
Step 5: Solder one end of the pre-cut and pre-stripped wires to the footswitch.
Step 6: Insert the other remaining ends of the pre-cut and pre-stripped wires into the
topside of the PCB and solder. You can can solder these on the topside as well. It is
easier this way, but you may burn a small amount of the PVC coating on the wires. This is
purely asthetic and won't damage the wires in anyway. But you can avoid this by
removing the PCB assembly and footswitch from the enclosure entirely (the PCB
assembly will still be attached to the enclosure via the DC jack wiring) so that you have
access to solder the underside of the PCB.
