11
Step 6: Add the two DIP8 IC sockets. Only solder the sockets to the board. The ICs
themselves will go into the sockets. Orient the sockets to the notch on the PCB lines up with
the notch on the sockets. When installing the ICs, match the notch on the body with the
notch on the PCB. If the IC has a dot, and not a notch, the dot will indicate pin 1. This is the
eyelet that is directly to the left of the notch on the PCB screenprint, and
is designated with
a square eyelet
. If your IC has both a notch and a dot, follow the notch.
Summary of Contents for Brown Face Tremolo
Page 20: ...20 Step 2 Connect the three 2 5 inch pre stripped and tinned wires to the enclosed jacks...
Page 28: ...28...
Page 30: ...30...
