Secret
25
x
y
8.5
1mm
35~40mm
■ Connect the stripped load wire into the terminal slot of the corresponding
connector, and tighten the screw (Note: the screw shall be in direct contact with
the wire core, the wire skin cannot be used for fixing, and the wire core exposed
outside the terminal slot shall not exceed 1/2 of the insulation blocking wafer).
A phase mark is arranged at the connector terminal port, as shown in the following
figure; please pay attention to the correspondence during wiring.
Terminal at the end of the load:
■ Insert the connector already connected with the wire into the Load interface on
the PCS, and pay attention to the phase correspondence.
