Troubleshooting
Leaks:
…Between head and cartridge
(1) Turn off the water supply to the fi lter and dispense water from
drinking water tap until water and airfl ow stops.
(2) Remove cartridge and inspect o-rings to make sure that they are
in place and clean.
(3 Install cartridge and turn on water supply.
If leaks persist, contact
Technical Support on 01494 838100.
…On other connections
Call
T
echnical Support
on 01494 838100.
Model: Taste Fresh Protection
Important Notice:
Read this performance data and compare the
capabilities of this system with your actual water treatment needs.
Test Conditions:
Flow Rate
= 0.5 gpm
Inlet Pressur
e = 60 psi (4.1 bar)
pH
= 7.5 ± 1
Temperature
= 68°F ± 5°F (20°C ± 2.5°C)
Operating Requirements
Pressure
=
30 – 72psi (2.1 – 5 bar)
Temperature
= 40° – 100°F (4.4o-37.7°C)
Turbidity
= 5 NTU Max
Do not use with water that is microbiologically unsafe or unknown
quality without adequate disinfection before or after the system. Systems
certifi ed for cyst reduction may be used on disinfected waters that may
contain fi lterable cysts.
Guarantee
This product is guaranteed for the period of one year from
the date of purchase against any manufacturing fault. The
guarantee is only valid if the product has been installed and used
in accordance with the manufacturers instructions and has not
been dismantled or interfered with in any way. Damage caused
to the product or by the product as a result of failure to use
the product in accordance with the manufacturer’s instructions
is not covered by this guarantee. Under this guarantee we
undertake at our discretion to repair or replace free of charge
the product or any part thereof that is found to be faulty. Costs
associated with the fi tting of a replacement product or part or
the removal of the product are not covered by this guarantee.
Loss or damage caused by the product (including consequential
loss) is not covered by this guarantee. This guarantee does not
affect your statutory rights.
Flow Rate: 1.89 Lpm Capacity: 1892L or 6 Months
* US EPA Maximum Contaminant Level
** No maximum contaminant level
† NSF test requirement of at least 50,000 3-4 micron particles per
millilitre.
The 3-4 micron size particle is a surrogate particle for Cryptosporidium
and Giardia cysts.
‡ US EPA Action Level for lead
NOTE:
Substances reduced are not necessarily in your water.
Filter must be maintained according to manufacturer’s instructions,
including replacement of fi lter cartridges.
Customer Help Line:
01494 838100
Monday to Friday 08.30 – 17.00
BWT UK Limited,
BWT House,
Coronation Road,
High Wycombe,
Buckinghamshire,
HP12 3SU
Tel:
01494 838100
Fax:
01494 838101
Email:
enquiries
@bwt-uk.co.uk
All trademarks are protected under European law and must not be reproduced
by third parties without express permission of BWT UK Limited in writing. As
part of BWT’s policy of constant product development, BWT reserves the right
to alter product specifi cations without prior notice.
1000R Cartridge
Standard 42
Chlorine-Class I
Particulates
(0.5 to<5 µm)
-Class I
Standard 53
Cysts †
Turbidity
Lead
(6.5 pH)
Lead
(8.5 pH)
Atrazine
Lindane
U.S EPA MCL*
-**
-**
99.95%
Reduction
0.5 NTU*
0.010 ppb‡
0.010 ppb‡
0.003 mg/L
0.0002 mg/L
Avg. Infl uent
Concentration
2.1 ppm
7,108,826#/ml
130,750 #/ml
37.4 NTU
0.15 mg/L
0.15 mg/L
0.0088 mg/L
0.002 mg/L
Avg.(Max) Effl uent
Concentration
0.02 ppm
15,896 #/ml
0 #/ml
(0 #/ml)
0.08 NTU
(0.08 NTU)
0.001 mg/L
(0.001 mg/L)
0.002 mg/L
(0.003 mg/L)
0.0002 mg/L
(0.0002 mg/L)
0.00005 mg/L
(0.00005 mg/L)
Avg.(Min)
Reduction
99%
99.8%
99.99%
(99.99%)
999.96%
99.95%)
99.3%
(99.3%)
98.6%
(98%)
97.7%
(97.7%)
(97.5%)
(97.5%)
4
01767SR_ TPF Operating Instructions.indd 4
02/06/2014 16:42
Performance Data
Taste Fresh Protection Drinking Water System
Installation and Operating Instructions
Model: TFPKIT
Speci ications:
Pressure Range:
30 – 72 psi (2.1 – 5 bar)
Temperature Range:
40 – 100°F (4.4 – 37.7°C)
Rated Service Flow:
1.9 Lpm
Filter Capacity:
1893 L
Parts Included:
• Filter head with built-in mounting bracket, and
integral push-fits
• 1000R filter cartridge
• Screws for mounting bracket
• Saddle tapping valve with tube attached
• Drinking water tap
• 6.35 mm (1/4”) plastic tubing
• For cold water use only.
• Make certain that installation complies with all local
bylaws and regulations.
• The contaminants or other substances removed or
reduced by the selected cartridge are not necessarily in
your water. Ask your local water supplier for a copy of
their water analysis.
• After prolonged periods of non-use (such as during a
holiday) it is recommended that the system be flushed
thoroughly. Let water run for 2-3 minutes before using.
• The filter cartridge used with this system has a limited
service life. Changes in taste, odour colour; and/or
flow of the water being filtered indicate that the
cartridge should be replaced.
Tools required:
• Phillips Screwdriver
• Towel
• Drill
• Tape Measure
Optional Materials:
• 6.3
mm
& 12.7 mm (1/4” & 1/2”) Drill Bit
• Cone-shaped grinding wheel
• File or Sandpaper
• Pencil
• 3.2 mm (1/8”) Drill Bit
• Adjustable Wrench
Installations:
• For standard installation on 15 mm copper, steel, brass or PVC
cold water pipe.
• Please read all instructions and precautions before installing and
using your under-sink drinking water system.
• Numbered diagrams correspond with numbered steps.
1. Selecting the Tap Location
NOTE: The drinking water tap should be positioned with function,
convenience and appearance in mind. An adequate flat area is
required to allow tap base to rest securely. The tap fits through a
12 mm hole.
CAUTION: Do not attempt to drill through an all-porcelain sink.
If you have an all-porcelain sink, drill through counter top next
to sink. The following instructions apply to porcelain-coated cast
iron and stainless steel sinks only. Consult a professional plumber
about installation on an all-porcelain sink.
(Continued overleaf)
Precautions:
WARNING
:
Do not use with water that is microbiologically
unsafe or of unknown quality without adequate
disinfection before or after the system. Systems
certified for cyst reduction may be used on
disinfected waters that may contain filterable cysts.
CAUTION:
This filter must be protected from freezing, which
can cause cracking of the filter and water leakage.
CAUTION:
Because of the product’s limited service life and to
prevent costly repairs or possible water damage,
we strongly recommend that the head of the filter
be replaced every ten years. If the head of your
filter has been in use for longer than this period, it
should be replaced immediately. Date the top of
any new head to indicate the next recommended
replacement date.
CAUTION:
Turn off water supply to head without cartridge if it
must be left unattended for an extended period of time.
Customer Help Line:
01494 838100
Monday to Friday 08.30 - 17.00
1
01767SR_ TPF Operating Instructions.indd 1
02/06/2014 16:42
01494 838100
01494 838100
30 - 72 psi (2.1 - 5 bar)
Specifications:
30 - 72 psi (2.1 - 5 bar)
If leaks persist, contact
Call Technical Support on 01494 838100
Technical Support on 01494 838100
...On other connections
mm
01494 838100
01494 838101
