BWT Disinfecton, Installation And Operating Manual

Page: 14 / 36

14
The brine tank comes standard with 10 kg of salt for commissioning the machine. 25 kg of salt should be
added subsequently, to fill the brine tank. The level of salt must be above water level. No water should be
visible. The salt needs some time to dissolve, in order to saturate the water.
See section: Connections for picture of machine connections.
The brine tank level sensor plug is connected to the machine via the M8 circular plug hanging on the left side
of the cabinet, next to the drip tray. The excess wire can be bundled behind the tank.To avoid waiting time for
the initial filling of soft water, bring five liters of water for commissioning the machine.
Bring 5L for start-up to avoid unnecessary waiting time.
The tank must be supplied with water from the softener during the process to avoid
lime scale in the cell.
Connecting the brine filter
The hose for the brine filter is taped to the bottom of the BWT Disinfecton.
1. Pull hose through lid.
2. Pull hose through grey square.
3. Unscrew filter and pull hose through black fitting, leave a 30mm gap between the bottom of the filter
and the bottom end of the hose.
4. Insert hose in filter and screw filter back on.
5. Activate manual regeneration of softener on the Sequence control menu.
Neuthox tank
Place the Neuthox tank on the right side, below the machine. Connect the supplied 6 mm black hose to the
machine, through the hole in the plastic spill tray, into the Neuthox
®
outlet push-in fitting on the cell. Place the
other end of the hose in the Neuthox tank.
Hose entry fitting must be horizontal to avoid leakage (connections should be from the bottom to ensure that
the support for the hose is properly seated).
See section: Connections for picture of machine connections.
The Neuthox tank level sensor plug is connected to the machine via the M8 circular plug hanging from the
cabinet’s right side, next to the drip tray. The excess wire can be bundled behind the tank.
Note
Caution