GasAlertMicro Charger II
English Instruction Sheet
D5755/3 Page
2
Trimmed and folded dimensions: 4.125 (W) x 5.875 (H)
Adding Another Charger
a
Warning
Maximum of six chargers can be connected together.
To add another charger, refer to Table 3, Figures 1, 2, and 3, and complete
the following procedures:
1.
Deactivate the charger.
2.
Remove the power cord from the POWER port.
3.
Remove the end plate. There are three Phillips screws on the
front and three Philips screws on the back.
4.
Attach the new charger. Ensure the charger connectors are
inserted correctly.
Note
Only one charger can be connected at a time.
5.
When all of the chargers have been connected, attach the end
plate to the last charger using the Phillips screws.
6.
A bottom cover plate must be attached to connect every two
chargers together to ensure stability of the units. Refer to Figure 3.
Use six Phillips flat-head screws for each bottom cover plate.
Table 3. Adding Another Charger
Item
Description
1
Phillips pan-head screw
2
End
plate
3
Charger
connectors
4
Phillips flat-head screw
5
Bottom cover plate
Figure 1. Adding Another Charger (Top)
Figure 2. Adding Another Charger (Bottom)
Figure 3. Attaching the Bottom Cover Plate
Mounting the Charger
The charger can be easily mounted onto a secure surface. To mount the
charger, refer to Table 4, Figures 4 and 5, and complete the following
procedures:
1.
Select a secure location for the charger to be mounted.
2.
Using the screws provided, attach the wall mounting plates to the
charger. Refer to Figure 4 and Figure 5.
Note
When mounting two or more chargers, an individual wall
mounting plate is required for each charger that is mounted.
3.
One Charger:
When the plates are mounted, measure a distance
of 2.38 in. (60.32 mm) to install the retaining screws.
Multiple Chargers:
If two or more chargers (that are attached
together) are being mounted, measure a distance of 1.64 in.
(41.70 mm) between each charger.