BVM ®2015 10 Printed 10/8/2021
Installing the Vertical Fin
Remove the 2 mm bolt from the bottom of
the rear aluminum rod.
You may wish to enlarge the hole for the
wire and connector to pass through.
NOTE: If the fin tubes (3) fit is a bit tight when
installing onto the fuselage, follow the (2) steps
below.
Use a Drum Sander to chamfer the ends of
the three tubes/rods.
Use 320 grit sand paper to stroke the rods
in the long direction. The grain should be
the same as the direction of insertion.
Apply a small amount of Lube to three
tubes.
Summary of Contents for GO FLY GOLD Grumman F-9F Cougar
Page 27: ...BVM 2015 27 Printed 10 8 2021...
