TROUBLESHOOTING GUIDE
The following information is intended as an aid in determining if problem exists. Pumps should be repaired only by authorized
BVA Service Center. For repair service, contact service center in your area.
Symptom
Possible Causes
Corrective Action
Application does not extend, move or
respond to pressurized fluid
• Overload condition
• Loose couplers
• Faulty couplers
• Pump malfunction
• Inadequate air supply
• Remedy overload condition
• Tighten couplers
• Replace couplers
• Contact service center
• Ensure air source can dedicate
7.8 CFM @ 110~175 PSI
Application responds to pressurized
fluid, but system does not maintain
pressure
• Overload condition
• Pump or valve malfunction
• Application/connection leaking
• Remedy overload condition
• Contact
Service Center
• Replace application/connection
Application responds slower than
normal
• Loose connection or coupler
• Restricted hydraulic line or fitting
• Application/connection leaking
• Tighten connection or coupler
• Clean and replace if damaged
• Replace application/connection
Application does not return fluid to
pump (i.e. cylinder will not retract)
• Malfunctioning coupler, damaged ap-
plication
•
Secure load by other means
.
Depressurize
pump and hose,
remove coupler and/or application,
then renew or replace
Application does not fully extend (cyl-
inder or spreader)
• Reservoir overfilled
• Fluid level in pump is low
•
Secure load by other means
.
Depressurize
pump and hose,
remove application, then drain fluid to
proper level
•
Secure load by other means
.
Depressurize
pump and hose,
remove application, then fill fluid to
proper level
Poor performance
• Fluid level in pump is low
• Ensure proper fluid level
5
MAINTENANCE
Important:
Use only a good quality hydraulic jack fluid.
Never
use brake fluid, transmission fluid, turbine oil, motor oil, alcohol,
glycerin etc. Use of other than good quality hydraulic oil will
void warranty and damage the pump, hose, and application.
We recommend Mobil DTE 13M or equivalent.
1. Inspect hoses and connections daily. Replace damaged
components immediately with BVA Hydraulics replacement
parts only.
2. Tighten connections as needed. Use non-hardening pipe
thread compound when servicing connections.
3. Use only good quality hydraulic fluid. We recommend Mobil
DTE 13M or equivalent.
Adding Hydraulic Fluid
1. Depressurize and disconnect hydraulic hoses from
application.
2. With pump in upright, horizontal position, remove the air
vent plug located on the top plate of the reservoir.
3. Use a small funnel to fill reservoir to within 3/4" (19mm) of
the opening.
4. Wipe up any spilled fluid and reinstall the air vent plug.
Changing Hydraulic Fluid
1. For best results, change fluid once a year.
2. Repeat step 2 on Adding Hydraulic Fluid, then pour used
fluid into a sealable container.
3. Dispose of fluid in accordance with local regulations.
4. Fill with a good quality hydraulic jack oil as recommended
above. Reinstall air vent plug.
Lubrication
When pump is operated on daily basis, the manufacturer
recommends installing an inline oiler and air dryer. Use SAE
grade oil (5W to 30W).
Storage
1. When not in use, depressurize and disconnect hydraulic
hoses from application.
2. Wipe clean, thoroughly.
3. Store in clean, dry environment. Avoid temperature
extremes.
4. For transportation or long storage, replace the air vent plug
with shipping plug.
5. Shield pump with a protective cover.
